Amplifier CELTO C2.6

Liên hệ để báo giá

Linear with Aluminum toroidal transformer
Low distortion Peak Limiter
Class H output stage (70% efficient)
Protection, Soft-start, Short-circuit, Over-voltage, Over-current, Over-load, DC output, Temperature
Simple layout and assembly for easy servicing
Genuine parts exclusively provided by world class suppliers
Compact and Lightweight 2U low depth format

Danh mục: CELTO Thương hiệu: CELTO

Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF)	2x 400W 8 ohms \| 2x 600W 4 ohms \| 1x 1200W 8 ohms (Bridge)
Overall gain	35dB (50 times voltage)
Sensitivity at 8 ohms	0.775Vrms (0dBu)
Signal to Noise Ratio (A weighted, 0 dB)	>110dB
Frequency Response (-1dB)	20~20000Hz
Typical THD (half power, 1kHz, 8 ohms)	<0.1%
Typical IMD (1kHz at 4:1, -20dB)	<0.3%
Crosstalk (1kHz)	>65dB
Slew Rate	>15V/us
Input Impedance	20 kΩ
Damping factor (1kHz, 8 ohms)	>500
Protections	Soft-Start, Short-Circuit, Over-Voltage, Over-Current, Over-Load, DC Output, Temperature
Operating Voltage	190~260VAC 50-60Hz
Preamp	Low noise and low distortion circuit, PeakStop Opto-Limiter
Power Supply (PSU)	Linear topology with toroidal transforner
Output stage	2-step Class H without cross-rail distortion (70% efficiency)
Cooling	Front to back airflow, Temperature regulated fans, Copper heat-sink for maximum heat transfer
Rear Panel	2 NEUTRIK XLR Input with latch, 2 NEUTRIK XLR Link ,2 NEUTRIK Speakon NL4, 2 speaker Binding post terminals, Stereo / Parallel / Bridge switch, Ground / Lift switch, Magnetic Breaker, PowerCon 20A (Included)
Speakon Wiring	SPK1 = 1+1- CH A / 2+2- CH B \| SPK2 = 1+1- CH B / 2+2- Not Used
Chassis	19″ 2U height, 378mm total depth
Weight Net / Gross	14kg / 16kg