Mixer DiGiCo S21

Liên hệ để báo giá

48 Flexi Input Channels
16 Flexi Aux / Sub-Group Busses
LR Master Buss
10 x 8 Full Processing Matrix
21 Dynamic Equalizers
96kHz Sample Rate

Danh mục: Digico S-Series Thương hiệu: Digico

Mô tả

Mixer DiGiCo, bộ tính năng chuyên sâu và chất lượng âm thanh hàng đầu của bảng điều khiển kỹ thuật số cao cấp của chúng tôi nằm trong tầm tay của mọi người. Làm quen với S21 bảng điều khiển trộn DiGiCo đẳng cấp thế giới với mức giá đáng kinh ngạc. DiGiCo SD Series, Mixer DiGiCo S21 tự hào có cùng thuật toán âm thanh độc quyền cộng với bộ xử lý ARM QuadCore RISC mới chạy hài hòa với lõi FPGA. Kết quả là quá trình xử lý nhanh hơn với mức tiêu thụ điện năng thấp hơn, tất cả được gói gọn trong quy trình làm việc mà các kỹ sư được kính trọng nhất trong ngành dựa vào, hiện đã có sẵn cho mọi người.

Thông số kỹ thuật Mixer DiGiCo S21

General Specifications	48 x Input flex-channels Mono/Stereo (equivalent of 96 DSP channels) 46 busses: 16 x flexi-busses Mono/Stereo (equivalent of 32 DSP busses), Stereo Master (2), Solo busses (2 stereo, 4 total), and 10 x 8 Matrix (8) 10 x Control Groups 1 x Compressor per channel and buss 1 x Gate per channel and buss (switchable to ducker, or compressor with side chain access) 16 x assignable 32 band Graphic EQs 8 x FX engines (reverbs, delays, w/modulation and enhancer) 21 x assignable DiGiTuBes 21 x assignable Multiband Compressors 21 x assignable Dynamic EQ’s User definable Macros An extremely high power headphone amplifier with 1/4 inch and mini jack socket 96kHz as standard 24 mic/line inputs 12 analogue outs 2 AES/EBU I/O (mono) Word Clock I/O 1 GPI and 1 GPO DVI out (for an external monitor) 2 DMI Card slots (up to 64 I/O per slot) 2 Ethernet connections for Networking 2 x 24 segment master/solo meters Touch sensitive rotaries with integrated switch & HTL 2 x multi-touch screens 21 x touch sensitive moving faders 4 x layers of banks of 10 faders Customisable bank and channel layout Snapshots Integrated USB2 Audio I/O interface for recording and playback of up to 48 channels
Audio Specification	Sample Rate 48kHz, 96kHz Processing Delay 2ms Typical @ 48k (48 Stereo Channels, Stage Input Through L-R Buss to Stage Output) 1.1ms @ 96kHz Internal Processing Up to 40-bit, Floating Point A>D & D>A 24-bit Converter Bit Depth Frequency Response +/- 0.6dB (20Hz – 20kHz) THD <0.05% @ Unity Gain, 10dB Input @ 1kHz Channel Separation Better Than 90dB (40Hz – 15kHz) Residual Output <90dBu Typical Noise (20Hz – 20kHz) Microphone Input Better Than -126dB Equivalent Noise Maximum Output Level +22dBu Maximum Input Level +22dBu
Processing Channel Specification Input Channel	Input Name: User-Defined Channel Selection: Mono / Stereo Input Routing: Main Input Analogue Gain: -20 to +60dB Phase: Normal / Reverse Digital Trim: 40 to +40dB Delay: 0 – 682ms DiGiTuBe Drive: 0.01 – 50.0 Bias: 0 – 6 LPF: 20 – 20kHz, 24dB/Oct HPF: 20 – 20kHz, 24dB/Oct Insert A: (Pre EQ/Dyn) On/Off Equalisation 4 Band EQ: Parametric or Dynamic (Low/Lowshelf, Lower-Mid/Lowshelf, Upper-Mid/Hishelf, Hi/Hishelf) On/Off Freq; 20 – 20kHz Gain; +/- 18dB Q: 0.1 -20 (Parametric) / 0.10-0.90 (Shelf) Dynamics 1: Single or 4 x Multiband (3-Band) Compressor; On/Off Threshold; -60 – 0dB Attack; 500us – 100ms Release; 5ms – 5s Ratio; 1:1 – 50:1 Gain; 0 to +40dB Hi Crossover; 20Hz – 20kHz Lo Crossover; 20Hz – 20kHz Knee; Hard, Med, Soft Dynamics 2: On/Off Gate / Ducker Threshold; -60 – 0dB Attack; 50us – 100ms Hold; 2ms – 2s Release; 5ms – 5s Range; 0 – 90dB Key; Any Source Key Listen Freq/Width; 20 – 20kHz Compressor; On/Off Threshold; -60 – 0dB Attack; 500us – 100ms Release; 5ms – 5s Ratio; 1:1 – 50:1 Gain; 0 to +40dB Link; Any Channel / Buss S/C Source : Any Source S/C Listen : On/Off S/C Filter Freq/Width: 20Hz – 20kHz Insert B: (Post EQ/Dyn) On/Off Mute: Channel Mute Solo: Solo Buss 1 / Solo Buss 2 / Both, Channel Safe: Socket Properties, Input Route, Mono/Stereo, Label, Filters, Trim, Delay, Tube, Insert A, EQ, Dyn1, Dyn2, Insert B, Aux, Group Assigns, Pan, Fade, Mute, Direct Outs, Full Safe Output: Routing Buss, Insert A, Insert B, Direct: Post-Fade Fader: 100mm Motorised Fader ∞ to +10dB
Processing Channel Specification Aux / Group / Matrix Output	Name: User-Defined Phase: Normal / Reverse Digital Trim: -40 to +40dB Delay: 0 – 682ms DiGiTuBe Drive: 0.01 – 50.0 Bias 0 – 6 LPF: 20 – 20kHz, 24dB / Oct HPF: 20 – 20kHz, 24dB / Oct Insert A: (Pre EQ/Dyn) On/Off Equalisation 4 Band EQ: Parametric or Dynamic (Low/Lowshelf, Lower-Mid/Lowshelf, Upper-Mid/Hishelf, Hi/Hishelf) On/Off Freq; 20 – 20kHz Gain; +/- 18dB Q: 0.1 -20 (Parametric) / 0.10-0.90 (Shelf) Dynamics 1: Single or 4 x Multiband (3-band) Compressor; On/Off Threshold; -60 – 0dB Attack; 500us – 100ms Release; 5ms – 5s Ratio; 1:1 – 50:1 Gain; 0 to +40dB Hi Crossover; 20Hz – 20kHz Lo Crossover; 20Hz – 20kHz Knee; Hard, Med, Soft Gate / Ducker Threshold; -60 – 0dB Attack; 50us – 100ms Hold; 2ms – 2s Release; 5ms – 5s Range; 0 – 90dB Key; Any Source Key Listen Freq/Width; 20 – 20kHz Compressor On/Off Threshold; -60 – 0dB Attack; 500us – 100ms Release; 5ms – 5s Ratio; 1:1 – 50:1 Gain; 0 to +40dB Link; Any Channel/Buss S/C Source: Any source S/C Listen: On/Off S/C Filter Freq/Width: 20Hz – 20kHz Insert B: (Post EQ/Dyn) On/Off Mute: Channel Mute Solo: Solo Buss 1 / Solo Buss 2 / Both, Channel Safe: Mono/Stereo, Bus Mode, Label, Filters, Trim, Delay, Tube, Insert A, EQ, Dyn1, Dyn2, Insert B, Group Assigns, Fade, Mute, Direct Outs, Full Safe Output Routing: Outputs, Insert A, Insert B Fader: 100mm Motorised Fader ∞ to + 10dB

Mixer DiGiCo S21

Thông số kỹ thuật Mixer DiGiCo S21

Sản phẩm tương tự

Đăng nhập